1. The worm Cast Iron equipment reducer can get a huge gear ratio, and the larger output torque is smaller sized compared to the staggered axle gear mechanism.

2. The two teeth of the worm gear are in line get in touch with, and the bearing capability is much greater than that of the crossed helical equipment mechanism.

3. The worm equipment reducer transmission is the same as the screw get, which really is a multi-tooth mesh drive, therefore the transmission is steady and the sound is very small.

4. The worm equipment reducer has self-locking real estate. When the lead position of the worm is smaller compared to the equivalent friction angle between the meshing teeth, the system has self-locking home, and the reverse self-locking can be realized, that’s, the worm steering wheel can only be powered by the worm, and the worm can not be powered by the worm steering wheel. For instance, in the self-locking worm system used in its heavy machinery, the reverse self-locking house can serve as a protection protection.

5. The worm gear reducer has high transmission efficiency and serious wear. On the other hand, the relative sliding swiftness is large, causing severe use on the tooth surface area and serious heat era. In order to dissipate high temperature and reduce wear, materials with better anti-friction and anti-wear properties and good lubrication devices are often used, so the cost is high.

6. The axial pressure of the reducer worm can be huge, and the anti-lock bearing is normally installed on the worm shaft of our factory.